Restore

Description

HEAVY OIL/GREASE SPOTS ON CONCRETE:

Pretreat with a Multi-Purpose Degreaser Soap or degreaser of your choice. Restore can be applied around oil/ grease areas to allow maximum penetration and dwell time for the oil lifting process without 2-stepping the cleaning area. DO NOT introduce or add Sodium Hypochlorite (Bleach) into Restore.

LIGHT TO MEDIUM TYRE MARKS ON CONCRETE OR SIMILAR SURFACES:

Apply a dilution of 1:10 – 1:15 of Restore directly onto the surface and immediately clean / rinse off with medium-pressure wash or surface cleaner. Dwell time as required.

LIGHT & SURFACE RUST REMOVAL:

Apply up to a dilution of 1:1 of Restore with water. Apply directly to the surface. Pre-wet area first for rust removal application due to ratio strength. The product will dissolve the rust slowly. For the vertical surface, restore will dissolve the rust from the top down without corrosive fumes. Agitation may be required for heavy stains. Rinse the area with a pressure washer.

Mix ratios – For heavy cleaning/restoration 1:5 For moderate cleaning/restoration 1:10 For light cleaning/restoration 1:20.

HEAVY TYRE MARKS ON CONCRETE OR SIMILAR SURFACES:

Apply a dilution of 1:5 – 1:8 with water of Restore directly on the surface and immediately clean / rinse off with medium-pressure wash or surface cleaner. Repeat the process if deep tyre burns are still evident.

Prevention:

Keep out of reach of children. Read label prior to using Restore.

Important Notes: Restore

Do not apply and allow the product to dry on the surface.
Avoid application in full sun, on hot surfaces or in hot windy conditions. Ensure weather conditions are suitable; do not apply if the surface temperature is below 10°C and raining. Do not apply if the temperature exceeds 30°C.